EN_SWD=DISABLE, RCO_PWR_MODE=RCO_PWR_HIGH, DPPU_OPT_SEL=RES1P2K, DIS_USB_PULLUP=CONNECT, DIS_FLSH_POWER=ENABLE
MISC register
| RCO_PWR_MODE | RCO VDD selection 0 (RCO_PWR_HIGH): The highest RCO VDD setting, RCO current 630nA 2 (RCO_PWR_MIDDLE): The middle RCO VDD setting, RCO current 350nA 3 (RCO_PWR_LOW): The lowest RCO VDD setting, RCO current 200nA |
| EN_SWD | enable swd register when SWD is selected in PIO_FUNC_CTRL 0 (DISABLE): disable SWD 1 (ENABLE): enable SWD |
| DIS_FLSH_POWER | flash power disable 0 (ENABLE): flash power is depend on the value DIS_FLSH of PMU_CTRL2 1 (DISABLE): flash power is off |
| DIS_USB_PULLUP | USB pull resister connection 0 (CONNECT): USB pull up resistor state depend on other 3 USB control register 1 (DISCONNECT): USB pull up resister is disconnected |
| DPPU_OPT_SEL | pull up strength source. 0: from DPPU_OPT_POL, 1: from usb device 0 (RES1P2K): 1.2kohm 1 (RES2P3K): 2.3kohm |
| DPPU_OPT_POL | swap pull up strength value |